Hydro Gen 1200ml

Description

About Our Hydro Gen

The Hydro Gen sits within the most therapeutic range of hydrogen inhalation at 1200ml per minute it is the same designed machine as the Hydro Nova just slightly lower output, and the price point is lower because of this. The Hydro Gen is very well designed for practical use. The handle is on the top, for easy to move, the weight is low, at 12 kilos with the water in the machine. This is a very practical therapeutic Hydrogen and Oxygen.

Which Machine is Right for you?

Please see the comparison chart below to find the best device for your needs.

• Hydro Gen 1200ml/min – Ideal for general wellness, health enthusiasts, longevity, better sleep, and mild energy boosts. Great entry/mid-level choice if you’re looking to maintain or improve your health.
• Hydro Nova 1500ml/min – Designed for active individuals or those facing mild to moderate health challenges. Offers faster recovery from workouts, inflammation support, and enhanced energy, this is our intermediate level.
• Immortal 3000ml/min – Is our range of most therapeutic output. Perfect for athletes looking for peak performance and those with chronic health conditions seeking maximum therapeutic benefits.
• Hydro Medic 3000ml/min – Has the same therapeutic benefits of the immortal yet it has been made for Hospitals and is even more robust machine for heavy use.

Why Choose a Higher Output Model?

While all our machines deliver hydrogen/oxygen benefits, a higher output means:

• Faster results – More hydrogen per minute supports quicker recovery and deeper cellular impact.
• Greater therapeutic effect – Particularly important for chronic illnesses, pain management or performance enhancement.
• Time-saving – Higher output means shorter inhalation sessions for the same dose.
• Flow Rate and Intensity – The higher the flow rate may possibly help more with chronic issues

Specification 

• USA made SPE electrolyzer from the United States N117 hydrogen oxygen separation without catalyst addition
• Quality certificate (CE) EED35Q814561/ EED35Q814561 
• Listed as a Medical Device in China for Rehabilitation CAAP2026006
• Output up to 1200ml per minute 66.6% Hydrogen 33.3% oxygen.
• Dimensions 22 x 42 x 42 cm
• You can change the output to either 450ml, 900ml or 1200ml
• Weight 9.8 kg (without water in the tank)
• Noise Level 20 db very quiet
• Requires distilled water to be added to the machine
• The water tank can hold 2.6L of water
• Timer can be set for up to 8 hours continuous run time
• No PFA Forever Chemicals in the whole machine
• Independent research and development of SPE pure water type electrolyzer (imported from the United States N117 hydrogen oxygen separation without catalyst addition
• Built-in mixing of hydrogen and oxygen
• Intelligent sensor detection array
• Explosion-proof device triple protection
• Environmental protection materials superior performance
• Intelligent water quality detection
• Purification humidification
• Intelligent cooling system air cooling heat dissipation water circulation
• One-way sealed humidifier
• Intelligent voice broadcast
• Lifespan 10,000 hours
• Comes with One Filter that will last approximately 12 months, replacement filters cost £39.00 for a pack of two
• Included is A TDS Pen to measure the quality of the distilled water worth £19.50
• Included is 3 Breathing Cannulas, so you can breathe in the Hydrogen and Oxygen. worth £25.00

Only Use Distilled Water 

It is important to only add distilled water to your Hydro Gen machine. If you use tape water, or mineral water, you can clog up the electrode plates in the machine. Thankfully there is an extra safety feature on The Hydro Gen, that will tell you straight away if the distilled water is not clean enough.

Most people think that if you buy distilled water online, or make your own distilled water, it will always be of a high standard, and near to 000ppm, yet this is not always the case. As some small particulars can get into the distilled water by mistake. This is why it is worth to double check the quality of the distilled water you put into your machine.

A TDS pen is a small device that you can double check the water quality before it goes into the machine. To use a TDS pen, all you need to do is turn the pen on and put the end of the pen into the distilled water you have bought or made, and we are looking for a reading of 0002 ppm or less the closer to 000ppm the better, if you get this reading the water is more than OK to put into your machine

This is the only potential issue we come across over the previous 7 years with our hydrogen and oxygen machines, and this is why we have added the extra sensor inside the machine, and with all customers purchasing The Hydro Gen, we now include a Free TDS pen. This way the one issue that use to come up very occasionally, with customers putting in the wrong water we have solved, and since we have had this new set up, touch wood we have not had one single issue.

How Much Distilled Water Do You Need?

For Your Hydro Gen, you will need 2.6 liters of distilled water to fill it up. This machine comes with a water level sensor to tell you if the water level is low, plus on the back of the machine you can also physically see with your own eyes the water level. When the water is low, all you need to do is to top up the water level, to the mark shown on the machine, if by mistake you added too much water you can simply drain out, from the back draining tube.

We estimate that with average use you will use around 5 liters of distilled water every 2 months.

User Manuel

We supply a full manual and a video how to set your machine up, with all of our orders. If there is anything you are unsure about before you buy, please contact, Alejandra in our customer service

2 Year Warranty

For peace of mind, we give all of our customers 2 years warranty, please click below to read the full details.